Mark Elson

One of the myths about lighting control systems is that you can only install them if you’re building a new house, where the walls aren’t built yet, or if you’re performing a major remodel, where all of the walls are torn down. This myth perpetuates on the assumption that you need to run lots of wire while the framing is exposed. It’s true that once the drywall is up, pulling wire becomes prohibitively expensive because of the labor required. But I’m here to bust the myth that you can’t have fun with your lighting in a finished home. In the case of lighting dimming control, you can enjoy many of the features you’d find in a whole-house wired system, without the wire and the accompanying labor expense.

It’s no surprise that consumer electronics have become increasingly dependent upon professional installation. Consider the following categories: satellite antennae, A/V distribution systems, projectors and screens, wholehouse control, lighting and dimming systems, content-sharing DVR networks, and of course wall-mounting and wire-pulling for flat-panel TVs. Want to talk about remote access to media servers and CCTV cameras via Ethernet? A system’s operation is programming intensive and depends on physical installation, which requires construction expertise. There’s so much going on behind your walls and in your attic. I wouldn’t want to take responsibility for all of it at my house, and I know my wife wouldn’t want me to, either. I bang up my walls enough, schlepping a retractable ladder from the garage up three flights of stairs to the master bedroom just to change a 9-volt smoke alarm battery. Drill holes in my walls? Me? Are you kidding? In this article, I’ll help you find your closest local professional installers and provide an easy method to help you make the right selection.